Wizardmon digimon figurine
15cm tall Wizardmon figure I created for my best friend out of a low poly version I found on the internet. It can be smoothed and painted for a better result. I used sand paper but you can use the acetone vapour mehod as well.
For the finish I sprayed some white plastic primer (Vallejo brand), and then used Vallejo model paints (acrylics in small bottles). Finally a layer of glossy vernish to protect the paint.
Print level: Intermediate
Infill Level: %
Model originally printed on: Zortrax M200
Recommended print settings:
Support 20% minimum
Layer height: 0.19mm