The Wish 1.01
“Grant me a wish, my beautiful star ! “
This model is in 2 parts : the faerie and the shooting star. the star will be printed flat, and you can glue it in a notch in the floor behind the faerie.
i made a little error and put the assembled STL (faerie+star together) in the archive. It’s corrected with the new version 1.01 (each part separated)
Print level: Beginner
Infill Level: %
Model originally printed on: solidoodle 4
Recommended print settings:
The faerie can be printed at 70% of the scale without problem for a faster print. Don't go under or you can get a problem with the wings. Print without support.
0.15mm layer height, 15% infill, 2 perimeters for the Faerie
0.2mm layer height, 10% infill, 2 perimeters for the shooting star
Tested with slic3r 1.2.9 and Simplify3d