Red, white and blue house
This is a model of the white house in the USA with a flying saucer shooting a laser beam. The design was inspired by the movie Independence Day and was printed for the 4th of July celebrations in the USA.
The files are designed to print the house in 3 pieces (the white and grey sections are actually one piece in the files but we ran out of white filament), there are 4 pins the line up the three sections of the building. Support removal for the middle section can be tricky so dissolvable filament would be a good move here. Need to print 4 of the ‘5_8 pins’, all the parts were printed in ABS with 2 layers and 10% infill.
Due to the tricky support removal and assembly required this is an expert level print. It can be made easier if you use dissolvable filament as the support material.
Infill Level: %
Model originally printed on: Makerbot Replicator 2X
Recommended print settings: