‘Love you’ photo frame-Valentine’s Day
This ‘love you’ letters frame holder is a photo frame where you can pop in a photo of your loved one, a special place you share together, your pet or even your favourite car or bike!
The frame ensures your photo does not bend easily and can support larger/heavier photos than the ‘Love you letters’ only. Makes a great gift and is a relatively easy print.
Print level: Beginner
Infill Level: %
Model originally printed on: Makerbot Replicator 2X
Recommended print settings:
Printed in ABS, 3 layers, 10% infill, small amount of supports required. Supports can be a bit difficult to remove because the gap in the letter is 0.5-2mm (where the photo slots into), a flat screwdriver or similar should do the job pretty easily. The stand at the back of the frame clips into the frame to have an upright frame and the frame ensures the photo will not bend easily, prints in approximately 2 hours.