Joint Strike Fighter Jet
This is a 3D model of the joint strike fighter aircraft with wings, tail fins, cockpit and engine. There are several photos of the JSF doing low flybys, climbing and banking. A short video of the stills can be found on Youtube Joint Strike Fighter video
Print level: Beginner
Infill Level: %
Model originally printed on: Makerbot Replicator 2X
Recommended print settings:
This model of a joint strike fighter jet was 3D printed in two pieces that were then glued together afterwards, this allowed for better detail in the model and no supports were needed. There are two pins included that allow the two halves to line up spot on. It was printed in ABS with 2 layers and 10% infill. The full 3D model is also uploaded in STL format if you want to print it in one piece. This is an easy print for beginners if it is printed in two separate halves and then joined together with the clips included in the files. If it is printed in one piece it will require some support removal after the print.