Championship Thresh LOL
Championship Thresh figure, one of the characters from League of Legends. The model I found had the original mesh of the videogame and was unposed. I fixed the mesh (plenty of holes), posed the character and weapons in Zbrush, separated the different pieces and decimated and prepared everything to be printable. Hope you like it!
Print level: Expert
Infill Level: %
Model originally printed on: Zortrax M200
Recommended print settings:
Two files, one the body and the other the lamp and the shoulder plates. These plates must be attached to the body after print.
Layer height: medium, I printed it on 0.19 mm
Infill: medium, preferebly not light because of the thin parts that appear very britle.
Supports: 20% or more recomended
Overall quite a complex piece, took me 16 hours to print and remove supports
I do not recomend scaling the model down, some parts would lose detail and others would become too fragile.
For postproccessing, I used XTC coat, acrylic white primer and acrylic paints, and finished with a glossy vernish.