I was inspired to make this after the final episode of Call the Midwife which showed a wind up carousel.
After printing and assembling I found that some of the parts didn’t quite work the way I had intended. I altered these firstly to simplify the model and secondly to make assembly easier.
Most of the model was printed with an infill of 20%, the smaller parts I printed at 100%.
The model does need assembling and gluing, I used a good quality superglue. To help with the assembly I have included a PDF with assembly instructions.
Print level: Beginner
Post Processing: No
Infill Level: 10-20%
Material Type: Solid Filament,PLA,ABS
Print Time: 5-10 Hours
Model originally printed on: Geeetech MeCreator2
Recommended print settings: